Contact Us

Water Leak Detection And Fault Finding In Melbourne

  • Home
  • Water Leak Detection & Fault Finding

We Find The Leak Before We Open The Wall

A hidden leak almost never turns out to be where the damp patch is. Water tracks along joists, slab edges and pipe runs before it appears, so leak detection in Melbourne starts with the meter and the pressure test. Measured Plumbing traces water leaks across the inner city and inner east, isolating each part of the system until the loss can be attributed to one line, one fixture or one connection.
CALL 0416 812 147

What A Hidden Leak Usually Turns Out To Be

Once the system is properly isolated, most unexplained water loss lands in one of a short list of places.

A pinhole in old copper: weeping quietly inside a wall or subfloor for months before it shows.

A failed shower membrane or grout line: water passing behind tiles, with no pipe fault at all.

A slab leak: a supply line under concrete, often showing first as a warm patch on a floor.

A leaking cistern or inlet valve: a slow internal loss that never reaches the floor but reads on the meter. Faults in the pan, cistern or mixer are repaired on the spot.

A failed flexible hose or tap connection: dripping inside a vanity or under a sink.

A hot water unit or relief valve discharging: constant loss that looks like normal operation on an ageing hot water system.

An irrigation line or outside tap: losing water below ground where nothing is visible.

A leaking water service between the meter and the building: common in older properties with long supply runs.

Two of those are not plumbing repairs at all, which is exactly why guessing is expensive. Opening a wall to find sound pipework costs money and answers nothing.

Signs It Is Worth Booking Leak Detection

Most people arrive here after a bill. These are the signals worth acting on.
  • A water bill that has jumped with no change in how the property is used.
  • The meter still turning with every tap, toilet and appliance switched off.
  • A damp, stained or blistering patch on a wall, ceiling or skirting.
  • A musty smell in one room that does not clear with ventilation.
  • A section of floor warm underfoot, or timber that has started to lift or cup.
  • Water pressure that has dropped across the property without explanation.
  • Mortar staining, efflorescence or moss on external brickwork below a wet area.
None of these confirm the source on their own. They confirm that water is escaping, which is the point at which testing is cheaper than demolition. Active flooding is a different job, attended as an emergency call-out.
REQUEST A CALLBACK

Leak Detection And Fault Finding Services In Melbourne

The work is diagnostic before it is anything else. The aim of the visit is a location and a cause.

Meter testing and loss verification

The meter read and monitored with the property isolated to confirm and quantify the loss.

Section isolation and pressure testing

The system split down line by line so the leak can be attributed to one run.

Concealed pipe leak location

In-wall, ceiling, subfloor and under-slab supply leaks traced to a point before access is cut.

Wet area and shower leak diagnosis

Separating a failed membrane, grout or shower screen from an actual pipe leak.

Fixture and appliance fault finding

Cisterns, mixers, flexible hoses, dishwashers, washing machines and hot water units checked as sources.

Water service and boundary leak location

Losses between the meter and the building, and identifying where responsibility sits with the water authority.

Repairs once the fault is found

Pipework, fixtures and connections repaired, including burst pipe repair where the pipe has failed outright.

Written findings for insurers and owners corporations

What was tested, what was found, and where the fault sits, in a form a committee or property manager can act on.
Water backing up through a drain is a drainage fault, and failed or blocked drain lines are diagnosed as a separate scope. Suspected gas leaks are handled by a licensed gas fitter.

Why Choose Measured Plumbing For Leak Detection

Diagnosis before demolition

We locate the fault to a point, so access stays minimal.

15+ years' experience

Including commercial construction and complex fit-outs.

Testing you can see

We show you the meter readings and pressure results.

Findings in writing

A report an insurer, property manager or committee can act on.

We fix what we find

The same licensed plumber carries out the repair.

Wet areas assessed honestly

We call a membrane failure a membrane failure.
  • Testimonials

Recent Customer Feedback

I was extremely impressed by the efficiency, professionalism and service provided. Cannot recommend them enough!

Jack Sassella Google Review

Had an issue with my washing machine, hot water service and toilet all in the one day, ultra quick turnaround and couldn't have been more thankful for the job done. Completely saved the day and will absolutely use again for my next issue.

Chris Bowen Google Review

I recently used this new plumbing company and couldn't be happier with the experience. From the initial phone call through to the completion of the job, the team was professional, friendly, and incredibly responsive. Read More

Sam Staples Google Review

How A Leak Detection Visit Runs

  • We take the history: bills, when it started, what is wet, what has already been tried.
  • We shut down every fixture and appliance and monitor the meter to confirm the loss.
  • We isolate the system in sections and pressure test to narrow the loss to one line.
  • We check fixtures, wet areas and the hot water unit as sources before touching any structure.
  • We pinpoint the fault and, where access is needed, cut it in the smallest sensible place.
  • We explain the findings, put them in writing, and quote or carry out the repair on the spot where possible.

What Affects The Cost Of Leak Detection

A straightforward leak on an accessible pipe is often located quickly. Testing takes longer on larger properties, where several lines or fixtures need isolating, or where the suspect pipework runs beneath a slab or behind tiles. Apartment buildings may also need access to common areas, or a shared riser isolated.

Leak detection is quoted separately from the repair, so you can confirm the cause before approving further work. Once the fault is located, Measured Plumbing provides a written repair quote that states any reinstatement required. Where a claim is likely, the test results and photographs are recorded as the work proceeds and written up for an insurance and make-safe claim.

ENQUIRE NOW

Water Leak Detection FAQs

0416 812 147

Water Leak Detection FAQs

Turn off every tap and appliance, make sure no toilet is filling, then watch the water meter for five minutes. If the dial keeps moving, water is escaping somewhere on the property. Note the reading before and after, because those two numbers make the first part of a plumber's visit much faster.
In most cases the location can be narrowed to a single line or fixture through meter testing and section isolation, without opening anything. Access is only cut once the fault has been pinpointed, and then only where it is needed to make the repair.
Both are common, and they are told apart by testing. If the leak only appears when the shower is in use and the pipework holds pressure, the likely cause is a failed membrane, grout or screen, which is a waterproofing and tiling repair.
Pipework on the property side of the meter is the owner's responsibility, and the water authority's assets sit on the other side. Locating the leak establishes which side it is on, and the findings can be provided in writing if the authority needs to be contacted.
A single-line internal loss is often traced within one visit. Larger properties, multiple simultaneous leaks, apartments with shared risers and under-slab pipework take longer, and the expected time is discussed before the booking is confirmed.
Melbourne retailers do consider concessions for concealed leaks in some circumstances, and they generally require evidence that the leak was hidden and has since been repaired. That is why the test results, the location and the completed repair are documented, so the claim can be submitted with something behind it.

Find The Leak Before It Finds The Floor

A leak that has already stained a wall has been running for a while, and every week it continues costs more in water and repair work. Measured Plumbing will confirm the loss, trace it to a point, and tell you plainly whether the fix is a pipe, a fixture or a wet area needing rework. Servicing inner Melbourne, with the findings and the scope both provided in writing.
CALL 0416 812 147
Call Now