Contact Us

Tap, Toilet And Fixture Repairs In Melbourne

  • Home
  • Tap, Toilet & Fixture Repairs

Washers, Cartridges, Cisterns And Shower Leaks, Fixed Properly

Inner-Melbourne homes carry a lot of older tapware, and a dripping kitchen mixer or a toilet that keeps refilling is usually a worn part, not a failed fixture. Measured Plumbing repairs and replaces taps, toilets, cisterns, mixers and shower fittings across Richmond and the surrounding suburbs. Original chrome tapware can often be kept and reseated, which is worth checking before anything is replaced.
CALL 0416 812 147

Leaking Tap, Toilet And Fixture Repair Services

Most fixture faults come back to a handful of wearing parts: washers and jumper valves, ceramic cartridges, cistern inlet and outlet valves, and perished seals behind a wall. Matching the right part to the fixture decides whether a repair lasts or needs redoing in six months.

Leaking tap repair: washers, jumper valves, seats reground and ceramic cartridges replaced in mixers.

Tap and mixer replacement: like-for-like changeovers and upgrades, including kitchen, basin and laundry sets.

Toilet cistern repair: inlet valves, outlet valves and flush mechanisms replaced to stop a cistern running.

Toilet repairs and replacement: loose pans re-seated and sealed, faulty seats and connectors replaced, and full pan and cistern changeovers. A pan that is blocked rather than faulty is a drain job.

Leaking shower repair: dripping shower taps, worn cartridges and failed wall breeches investigated before anything is opened up.

Basin, sink and laundry trough installation: fixtures installed, connected and waste lines tested.

Outdoor and garden taps: replaced, relocated or added, including hose cocks and isolation valves.

Isolation and stop valves: installed or replaced so a single fixture can be shut off without isolating the whole property.

SEND AN ENQUIRY

Why Choose Measured Plumbing For Tap And Toilet Repairs

Repair before replacement

We keep and reseat original tapware wherever it can be saved.

15+ years' experience

Commercial standards applied to small domestic jobs.

Several fixtures in one visit

We work through a job list in a single booking.

Clean workmanship

We protect surrounds, finish silicone neatly and leave the area tidy.

Inner-Melbourne coverage

Richmond, Cremorne, South Yarra, Prahran, Toorak, Hawthorn, Kew and Northcote.
  • Testimonials

Recent Customer Feedback

I was extremely impressed by the efficiency, professionalism and service provided. Cannot recommend them enough!

Jack Sassella Google Review

Had an issue with my washing machine, hot water service and toilet all in the one day, ultra quick turnaround and couldn't have been more thankful for the job done. Completely saved the day and will absolutely use again for my next issue.

Chris Bowen Google Review

I recently used this new plumbing company and couldn't be happier with the experience. From the initial phone call through to the completion of the job, the team was professional, friendly, and incredibly responsive. Read More

Sam Staples Google Review

Small Leaks Worth Booking Before They Grow

A dripping tap wastes water quietly, and a few of these faults do real damage if they sit.

  • A tap that drips after it is turned off firmly, or needs extra force to stop.
  • A toilet that keeps trickling into the pan, or refills by itself between uses.
  • A tap handle that squeaks, grinds or turns further than it used to.
  • Water marks on the ceiling below an upstairs bathroom, or on a wall beside a shower.
  • A loose or rocking toilet pan, which breaks the seal at the floor.
  • Damp or lifting grout at the base of a shower wall, where the wall connection may be leaking.

The last two are the ones that turn into damage bills. Water showing in a ceiling or wall cavity should be looked at, and if it is spreading, treated as an emergency call-out.

Repair The Fixture Or Replace It?

Repair is usually the first option and often the right one. A few conditions change that.
  • Parts availability: older imported tapware sometimes has no matching cartridge left in the country.
  • Body condition: a corroded or split tap body cannot be sealed reliably whichever parts go in.
  • Repeat repairs: a fixture rewashered several times is often worn past the seat.
  • Water efficiency: an older single-flush cistern uses far more water per flush than a current dual-flush unit.
  • Planned work: if a bathroom or kitchen is being redone soon, holding the repair until the renovation avoids paying twice.

Rental properties add one more consideration. A fixture already repaired twice in a tenancy is usually cheaper to replace than to keep attending, and a dual-flush changeover reduces the water charges passed on. Measured Plumbing gives the honest view on each fixture.

What Affects The Cost Of A Tap Or Toilet Repair

Fixture repairs are priced on time and parts, so the fault, the fixture and the access set the quote. A standard washer replacement is quick. A seized tap in an old wall, a cartridge sourced to suit an imported mixer, or a toilet needing the pan lifted and re-sealed takes longer. Booking several fixtures in one visit is more efficient than calling separately for each, and where a part has to be ordered, that is set out up front.

REQUEST A WRITTEN QUOTE

How A Fixture Repair Visit Runs

  • We check the fixtures on your list and identify the actual fault on each one.
  • We recommend repair or replacement for each fixture, with the reasoning explained.
  • We confirm the work, including anything that needs a part ordered in.
  • We isolate water at the fixture or the meter, and protect the surrounding surfaces.
  • We complete the repair or changeover, then test under pressure for drips and correct flow.
  • We clean the work area down and show you any parts we replaced.

Tap And Toilet Repair FAQs

0416 812 147

Tap And Toilet Repair FAQs

The seat the washer closes onto is usually worn or pitted, so a new washer cannot seal against it. Regrinding the seat, or replacing the cartridge in a mixer, is what fixes it properly.
Either the inlet valve is not shutting off, or the outlet valve seal is passing water into the pan. Both are replaceable parts, and a running cistern can waste a significant amount of water each day until it is dealt with.
Yes, and that is the more efficient way to handle it. Send the list of fixtures and what each one is doing, and the visit can be scoped so the parts are on hand.
A drip from the outlet when the taps are off points at the tap or cartridge. Damp grout, a musty smell or water appearing in the room below suggests the wall connection or waterproofing, which needs investigating before tiles come off.
Yes. Measured Plumbing works with property managers and owners corporations on tenanted homes and apartments, and documents what was found and replaced so it can go on file with the managing agent.
It depends on the fault, the fixture type and whether a part needs sourcing. The fixtures are assessed first and the work confirmed with you before it starts, so there is no guessing at the invoice stage.

Stop The Dripping Tap

A drip ignored for months is a short job for a plumber and a growing water bill for a household. Measured Plumbing will work through a list of taps, toilets and fixtures in one visit, repair what can be repaired, and replace only what genuinely needs it. Servicing Richmond and the inner Melbourne suburbs.
CALL 0416 812 147
Call Now