One fixture only, such as a basin or shower: usually hair, soap build-up or a blocked trap close to the fixture.
A toilet that clears then blocks again: wipes and sanitary items are the common cause, and they rarely pass on their own.
Every fixture draining slowly: points at the main sewer line.
Gurgling from a floor waste or toilet when a tap runs: air being pushed past a restriction further down the line.
Water surfacing at an outside gully: the sewer is blocked past that point and the gully is doing its job.
Water pooling in the yard after rain: a blocked or silted stormwater drain, not a sewer issue.
Blocked toilets
Blocked sinks, basins, showers and floor wastes
Blocked sewer lines
Blocked stormwater drains and downpipes
High-pressure water jetting
Drain camera inspection after clearing
Recurring blockages
Traced back to the cause, with the repair options set out in writing.
Cleared, then inspected
15+ years' experience
Straight advice on repeat blockages
Access protected
Inner-Melbourne coverage
I was extremely impressed by the efficiency, professionalism and service provided. Cannot recommend them enough!
I recently used this new plumbing company and couldn't be happier with the experience. From the initial phone call through to the completion of the job, the team was professional, friendly, and incredibly responsive. Read More
Most blockages cleared in older inner-city homes come down to a handful of repeat causes. Knowing them saves a second call-out.
Cost follows access and severity. A trap under a basin is a short job. A main sewer blockage that needs the inspection opening located, jetting to shift roots and a camera run afterwards is a larger scope.
Standard hours or emergency call-out changes it, as does property type, since apartments and shared lines often need access arranged with a manager first. Measured Plumbing confirms the scope before starting, and any repair found during the inspection is quoted separately.
It can. A cracked or blocked line under a slab will hold water against the building, and the damp often shows up well away from the pipe. That is a job for water leak detection before anything is opened up.